- GSM 900.
- Dimensions: 132 x 47.5 x 31 mm, 143 cc.
- Weight: 170 g.
- Display:Type Monochrome graphic, Size: 5 lines.
- Ringtones:Type Monophonic.
Customization. - Vibration: In battery 6 Ringing tone levels , 10 Volume levels.
- Memory.
- Phonebook
- Call records: 8 dialed, 5 received, 5 missed calls.
- Card slot: No.
- Data.
- GPRS: No.
- HSCSD: No.
- EDGE:No.
- 3G: No.
- WLAN: No.
- Bluetooth: No.
- Infrared port: No.
- USB.
- Messaging: SMS.
- Browser.
- Clock: Yes.
- Alarm: Yes.
- Games.
- Colors: Xpress-On covers, 4 basic, 7 metallic.
- Camera: No.
- Battery: Ultra Slim Battery,600 mAh, Li-Polymer, 127 g.
- Stand-by: 40 - 180 h.
- Talk time: 2 h - 3 h 20 min.
- Slim Battery, 900 mAh, Li-Ion, 143 g.
- Stand-by: 60-270 h.
- Talk time: 3-5 h.
Secret Codes:
- *#06# for checking the IMEI (International Mobile Equipment Identity).
- Information you get from the IMEI:XXXXXX XX XXXXXX X
- TAC
- FAC
- SNR
- SPTAC = Type approval code
- FAC = Final assembly code
- SNR = Serial number
- SP = Spare
- *#0000# To view Software Version.
- #746025625# [*#sim0clock#]Checks if the sim clock can be stopped. It is a stand by mode which saves battery. This code doesn't work with software version 4.59.
- *#92702689# [*#war0anty#].
- It has the the same data as 81xx and 31xx phones (with "Edit" button for purchase date, and "User data transfer").
Menu:
- Displays Serial Number
- Displays the Month and Year of Manufacture (0997).
- Displays the date where the phone was purchased (MMYY)
- you can place here the Purchasing Date .Note: It could be done once only so right carefully what you write.
- Displays the date of the last repairment - if found (0000).
- Enhanced Full Rate Codec (EFR):On: Enter *3370# and EFR will be activated after a reboot of the phone ( consumes more power )Off: Enter #3370# and EFR will be switched off after a reboot of the phone.
- 4720# Half Rate coded will be activated.
- #4720# Half Rate coded will be de-activated.
- Talk-time is reduced with about 5%Half Rate
- Network Monitor: There is a hidden menu inside your Nokia phone. If you want to activate it, you'll have to re-program some chips inside of your phone.
- Check your software version. You can continue if you have v4.33, v4.73 or v5.24.
- Take apart the phone.
- De-solder the EEPROM (ATMEL AT 24C64).
- Read out the data with an EEPROM programmer and save it to a file .
- If you have v.33 or v4.73, change the address "03B8" from "00" to "FF"
- If you have v5.24 then change the address "0378" from "00" to "FF".
- Write the new data to the EEPROM and solder it back to the phone.
- Power on your phone and you should have "Netmonitor" enabled.
- The Network Monitor gives you the given information.
- The Carrier number.
- MS RX Level in DBM.
- It received signal quality.
- MS TX power level C1 the Path loss criterion, used for cell selection and reselection.The range is between -99 to 99.
- Radio link timeout.
- Timeslot
- Indicates the transmitter status
- Informs on the Network parameters.
- Temporary Mobile Subscriber Identity.
- Cell identification.
- Mobile country code.
- Mobile network code.
- Location area code.
- Ciphering.
- Hopping.
- DTX.
Disclaimer. We can not guarantee that the information on this page is 100% correct.
